Add Your Heading Text Here

Back to home
2 (1)
6 (1)
mainbox4.original 1
AdobeStock_175913408 2 (1)

Sawn Timber

Contact us
Step 1 - Pressure Treatment
This is where the sawn wood is treated to ensure it has the longevity needed. The pressure chamber is vacuum sealed and preservatives are applied to treat the wood so that it will resist fungal and termite attack.
Step 2 & 3 - Stacking & Sorting followed by Kiln Drying
After pressure treatment, the timber will be sorted, properly stacked for drying in a kiln before the next step.
Step 4, 5 & 6 - Cross-Cutting, Moulding & Finger Joints
After the timber is dried, it will be ready for cross-cutting to get the useful wood pieces out of the timber. The cut pieces are then moulded and then joined into longer strips by the process of finger jointing.
Step 7, 8 & 9 - Lamination, Furniture Parts, Wood Working & Spraying
Subsequently the strips go through a lamination process to produce laminated boards. These are then further machined to various furniture parts that are cut in accordance to the design of a particular set of furniture. Wood working is a further process to bring the various furniture parts to the required shapes and smoothness. Finally, the various furniture pieces are sprayed with relevant paint and dried.
Step 10, 11 & 12 - Assembly, Packing and Storing
Assembly of the various pieces of furniture is done before these are packed in cardboard boxes. The complete packed assembly is then stacked and stored awaiting shipment to customers.

Rubberwood Sawn Timber 
Thicknesses : 4/8’’ – 1’’ up
Standard Size : 2’’-4’’ Width x 1’ up length

KUALA LUMPUR
No. 1 Block C, Jalan Indah 2/6, Taman Indah, Batu 11, 43200 Cheras, Selangor Darul Ehsan, Malaysia

+603-90759991

About us
Investor relations
Support

© Mieco Chipboard Berhad. Use of the information contained on this page is governed by Malaysian law and is subject to the disclaimers which can be read on the disclaimer page.